Carrot industrial juice extractor manufacturers fruit juicer
PLZ-2.5-type crushing Juice Unit
1. Processing capacity: 2.5T / H (referring to tomato);
2. Power: 12.5KW
3. Dimensions: 1500 × 700 × 2000mm;
4. Spiral speed: about 410 rpm;
5. Filter aperture: ¢ 0.3-2.0mm (standard 0.6mm, other specifications, please specify when ordering);
6. Complete automatic crushing, juicing, slag discharge process;
7. The machine is mainly suitable for all kinds of berry, pome fruit and all kinds of vegetable broken juice, such as: tomato, pineapple, apple, orange, pepper, spinach,
Ginger and other vegetables squeezing;
8. Structure: The equipment is mainly composed of the crushing device in the hopper, the front supporting seat, the spiral, the filter, the juice holding device, the rear support, the slag discharging trough And the like. The left end of the screw spindle is supported in the flow bearing seat, the right end is supported in the hand wheel bearing seat, and the motor drives the screw through a pair of triangular pulleys.
9.How it works: The main component of this equipment is to install the crushing device on the hopper, the flying knife on the rotor, the flying knife on its own axis in a fixed
Of the bottom knife rotation within the gap, so that fruits and vegetables get 3-10 mm particle size broken, direct access to the spiral juice system. The main component of the spiral juice is spiral, the bottom of the spiral along the direction of slag exports gradually increased while the pitch is gradually reduced, when the material is spirally propelled, due to the volume of the screw chamber is reduced, the formation of the material squeezing. The direction of rotation of the screw spindle from the feed hopper to slag tank direction, clockwise. The raw material is fed into the hopper and pressed under the helical propulsion. The squeezed juice flows through the strainer into the bottom juice holder, and the waste is discharged through the annular gap formed between the spiral and the conical part of the pressure regulation. The pressure head moves along the axial direction to adjust the size of the gap. For clockwise (from the slag tank device to the feed hopper to see the rotation hand wheel bearing, the pressure regulator head to the left, the gap is reduced, otherwise the gap becomes larger.) Change the size of the gap, that is, adjust the slag of the resistance, you can change the slag rate, but if the gap is too small, under strong extrusion, the part of the slag particles and the juice will be squeezed out through the filter, although the juice increases, but the relative decline in the quality of juice, voids The size should be depending on the user specific process requirements; 10.The equipment except the transmission parts are made of stainless steel.
Audited Supplier 
){kind=link}